Ahlborn ALMEMO 2390-5 Instructions d'exploitation télécharger pdf (Page 21)

Language setting

The function abbreviations can be shown in any one of three languages. You

can switch between languages in theDISPLAYMODE ´DM´ function, which can

be activated as and when necessary by holding down the FUNCTION key the first

time it is pressed; (see above).

Display mode function:

- - - d DM

Enter with PROG, PROG, ▲▼.., PROG

Example:

german

The letter indicates the language setting: d = German,

E = English,

F = French

Function designations in the interface protocol are always in Eng-

lish; (see Section 6.3.4).

5.3 Keypad

Each of the keys (6) initially has the normal function noted above it:

Function Normal Input

Programming PROG 

Selecting the measured value

and the measuring point: M ▲

CLEAR

Start and stop measuring point scanning START /

STOP ▲

Manual measuring point scanning, data output MANU /

PRINT ▼

Function selection FUNCTION ± /

ESC

If you press the PROG key, a digit or an abbreviation flashes in the display; i.e.

the device is in input mode and now the red lettering below the keys applies. In

this mode the following keys are available :±, ▲, ▼ for changing the input digit,

the  key as cursor key, and CLEAR for deleting the parameters. Input is com-

pleted as soon as the last digit has been confirmed by means of the  key or

input has been cancelled by means of the ESC key.

ALMEMO



2390-5 21

Display and keypad

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 59 60

Pas de commentaire

Ahlborn ALMEMO 2390-5 Instructions d'exploitation Page 21